ACETYLENE INJECTOR


Code: NFGF

By the long collaboration between O-I and Technology it was born a special line of product for acetylene application. One of the most specific system is the Acetylene Injector that has to be installed next to the molds in order to produce lampblack. In the years we have studied and produced several type of injector in order to satisfy the technical request of any productive site. The first aim of our product is the maximum safety and for this reason each injector is equi-pped with flashback arrestor as expected by standard UNI EN ISO 730 1-2. The components material of the system are stainless steel and brass (with low percentage of copper) as established by regulation UNI EN ISO 11114-1 e UNI EN ISO 11114-2. Every injector could be produced with one or two electrical valves as needed by different types of production. On request could be studied also a bypass in order to perform mainte-nance without stop of work. The maintenance of Injectors is one of the most important aspect to carry out in order to have the best performance of safety and efficiency.

TECHNICAL DATA


GAS: ACETYLENE

MAX PRESSURE IN: 1.5 bar

MAX PRESSIURE OUT: 1,5 bar

MAX FLOW RATE: 600Nl/min

COMPATIBILITY STANDARDS: UNI EN ISO 11114-1 / 2

GENERAL STANDARD: UNI EN ISO 14114 –ATEX 2014/34/EU

DIMENSIONS: VARIOUS

POWER EV: 24VAC/DC